How do I open, attach, and fold my Single Air 14" safely?

Short answer: Lay the monitor flat, screen up, and open the screen (up to 180°). Stretch the support to your laptop's width and clip it on. To fold it, lay it flat, fold the screen in, and check that the small flap closes properly.

Open it

  1. Lay the monitor flat with the screen facing up.
  2. Open the screen in the direction shown in the manual, up to a maximum angle of 180°.

Single Air 14" opening from the user manual: lay it flat, screen up, and open the screen up to 180°

Attach it to your laptop

  1. Pull the support open to the width of your laptop screen. It fits 13.3" to 17.3" laptops.
  2. Open the support rod, then stretch the support to the right size.
  3. The support rod only rotates clockwise, by 90°. Its maximum opening angle is 90°: folding it further damages it.
  4. Clip the monitor onto the top of your laptop screen.

Single Air 14" mounted next to a laptop screen from the user manual, with the support rod opening 90°

Fold it

  1. Lay the monitor flat with the screen facing up, then fold the screen in.
  2. When you store it, make sure the stand faces up and the wide edge of the screen faces down.
  3. Make sure the small flap closes properly before you store the screen.

Single Air 14" closing sequence from the user manual: lay it flat and fold the screen in

Safety tips

  • Always follow the opening and closing sequence to avoid damaging the device.
  • Don't press on the screen or use sharp tools near it. Remove the protective film before first use.
  • Plug and unplug the cable straight in line with the port, never at an angle.

Still not working?

Contact us at aura-displays.com/pages/support with a photo of the monitor on your laptop. We're available Monday to Friday, 9 AM to 5 PM (CET), following European summer and winter time (CET in winter, CEST in summer).

Also searched as: open, unfold, fold, close, clip on laptop, support rod, kickstand, outrigger, small flap, laptop size, Single Air