Single Play 14" troubleshooting: no picture, flicker, shaky or loose fit

Short answer: Most problems come from a laptop port that doesn’t carry video, from too little power (the monitor needs 5V/2A), or from a laptop screen that’s too thin or too small for the bracket. Find what you see below and follow the steps.

The screen stays black or shows “No signal”

  1. Check your USB-C port. It must support video: look for a DisplayPort or Thunderbolt symbol next to it. If it has none, try another USB-C port, or use option 2: the Mini HDMI to HDMI cable plus the USB-C to USB-A power cable (see the setup article).
  2. Using HDMI? The Mini HDMI port carries no power. Also connect the USB-C to USB-A cable for power.
  3. Check the input. Press Menu, go to Source, and choose the port you’re using: Type C1, Type C2, or HDMI.
  4. Unplug the cable at both ends and plug it back in firmly.

Single Play 14 side panel with the Menu button, plus and minus buttons, two full-function USB-C ports, and the Mini HDMI port labeled

Laptop USB-C port symbols that provide video and power: Thunderbolt and USB-C with DisplayPort

The screen flickers, dims, or turns off

The monitor has no battery and needs at least 5V/2A. Some laptop ports can’t supply that much.

  1. Plug the USB-C to USB-A cable into the monitor’s free USB-C port.
  2. Plug the USB-A end into a 5V/2A (or higher) USB power adapter (not included).

The screen is stuck on solid red, green, or blue

The screen went into its factory test mode, usually because it didn’t get enough power the first time you plugged it in. Plug the USB-C to USB-A cable into the monitor’s free USB-C port and into a USB power adapter of at least 15 W (not included), then follow the steps in My screen flickers, won't turn on, or is stuck on solid red, green, or blue.

It shakes or doesn’t hold on my laptop

  1. Make sure the bracket clamps the back of your laptop screen firmly.
  2. Thin laptop screen (0.24 in / 6 mm or less)? Slide a protective cap onto each bracket clamp. Six caps are in the box.
  3. Pull the stand on the back of the monitor all the way out so it supports the monitor.
  4. Check that your laptop fits: 14 in to 17.3 in, a screen lid 12.13 in to 16.81 in (308 to 427 mm) wide, and up to 0.33 in (8.5 mm) thick.

Sliding a protective cap onto each bracket clamp of the Single Play 14 for thin laptop screens

It shows the same picture as my laptop

  • Windows: open Settings › System › Display and choose Extend these displays in Multiple displays.
  • macOS: open System Settings › Displays, click the monitor, and set it as Extended display.

The picture or menu looks wrong

Press Menu, go to Reset, and confirm to go back to the factory settings.

Still not working?

Reach out to our support team at aura-displays.com/pages/support and include:

  • a photo or short video of the screen, the bracket on your laptop, and the cables plugged in;
  • your laptop model and operating system version;
  • which cables you’re using and which laptop ports they go into.

Also searched as: no signal, black screen, not working, USB-C no video, HDMI not working, flickering, turns off, not enough power, mirrors laptop, extend, shaking, wobbly, loose, falls off, doesn’t fit, lid too thick, rugged laptop, protective caps, OSD reset, Single Play Gen 2, Single Play 14 inch, clip-on laptop monitor, red screen, green screen, blue screen, factory mode, test mode